NORLYS

NORLYS Lillehammer 2275AL wall light – aluminium RAL 9006, 3000 K LED, narrow upward beam, DALI2

Name: NORLYS Lillehammer 2275AL wall light – aluminium RAL 9006, 3000 K LED, narrow upward beam, DALI2
Brand: NORLYS

NORLYS Lillehammer 2275AL is an aluminium-coloured RAL 9006 outdoor wall light with a vertical rectangular body. A single outlet directs a very narrow 4° beam upwards, creating an accent on the wall or facade above the fitting. A narrow beam in warm white The included LED source produces warm white light with a colour temperature of 3000 K. The complete fitting delivers 15 lm and consumes 4.5 W. When planning its position, allow for the concentrated distribution that highlights a selected vertical section of the surface. The manufacturer specifies this model for walls, facades and other architectural schemes. The area above the light needs to accommodate the upward beam, so check the position of cornices, canopies and recesses before installation. Light leaves the body through an outlet on one side only. Dimensions and finish The body measures 18.5 cm high, 8 cm wide and 11 cm deep. Compare these dimensions with the width of a pillar or the available strip of facade. Its slim vertical form takes up little wall width, while the 11 cm depth defines its projection from the mounting surface. The body is powder-coated cast aluminium in an aluminium-coloured finish, with a clear safety-glass cover. A silicone gasket and an EPDM cable gland complete the construction. Its plain, unadorned form allows the fitting to sit alongside modern or minimalist architecture without adding another decorative motif. Dimming and installation Light output is controlled within a DALI2 system, so the control installation needs to be planned alongside the power connection. The LED source and electronic driver are included, with no separate screw-base bulb to buy. A professional service technician replaces them after the power supply is disconnected. Class I requires a protective earth conductor and connection to the 220–240 V AC installation by a qualified electrician. Mounting uses two 5 mm holes with 45 × 130 mm spacing. IP65 provides protection against dust and water jets when correctly installed, with the connection seal specified for a round cable 7–10.5 mm in diameter.Show more

from 259,27 €

1 offer

See all offers