NORLYS

NORLYS Molde DC1901CS LED bollard, corten-effect finish, 80 cm, 3000 K, 24 V DC

Name: NORLYS Molde DC1901CS LED bollard, corten-effect finish, 80 cm, 3000 K, 24 V DC
Brand: NORLYS

The NORLYS Molde DC1901CS is an 80 cm outdoor LED bollard with a narrow body and a head that curves forward. Its CS finish is powder-coated aluminium in a corten-effect colour, approximately RAL 8011. The colour designation describes the coating: the body is not made from weathering steel.Positioning the slim bollardWith its plain upright body and unadorned head, Molde suits modern and minimalist garden layouts. It measures 11 cm across and 16.5 cm deep, including the projecting head. Compare those dimensions with the intended mounting position beside a garden path, terrace or driveway, keeping the fitting outside the actual walking or driving route.The manufacturer confirms IP54 protection and IK07 impact resistance. The transparent polycarbonate cover has a structured surface and UV stabilisation. Light is diffuse and shielded from above by the head. At 80 cm, this is a low-level outdoor fitting rather than a tall lighting column intended to illuminate an area from several metres above ground.Warm light and a separate 24 V supplyTwo integrated LED modules have a combined power of 7.2 W and a colour temperature of 3000 K. The complete luminaire delivers 505 lm. Use that figure when comparing bollards, rather than the higher output of the bare LED sources before losses within the fitting.This DC1901CS version requires an external constant-voltage 24 V DC power supply. It must not be connected directly to a 230 V mains circuit. The modules support dimming, but the appropriate supply and control arrangement must be selected as part of the installation design; the fitting does not replace those external components.Fixing and future servicingMounting uses four 7 mm holes spaced 18 × 50 mm apart. Fixing screws are not included. The manufacturer's ground anchors and mounting adapters are sold separately, so choose the fixing method to suit the substrate before ordering additional parts.A qualified person must select the power supply and carry out the electrical installation. The LED light source is replaceable by a professional service, not in the same way as an ordinary screw-in bulb. Allow for both the power connection and later access to the fitting when planning its position.Mostra di più

da 176,78 €

1 offerta

Vedi le offerte