STEINEL

NIGHTMATIQ twilight switch 1000W 1-75 lx IP54 anthracite 066130 STEINEL

Name: NIGHTMATIQ twilight switch 1000W 1-75 lx IP54 anthracite 066130 STEINEL
Brand: STEINEL

NIGHTMATIQ is a STEINEL twilight switch in an anthracite housing 95 × 95 mm and 38 mm deep, surface-mounted on an exterior wall. It is not a luminaire and not a motion detector — it is a standalone switch that turns on the lighting wired to it when darkness falls and turns it off at dawn. It does not react to movement — it reacts to light That distinction decides whether the device suits a given job. STEINEL states plainly "With motion detector: No": NIGHTMATIQ measures ambient light level and switches the circuit on that basis alone. The light therefore stays on all night rather than for a few minutes after someone walks past. This is the answer for a house number, a lamp by the driveway, façade lighting and shop windows — anywhere the light should simply burn from dusk to dawn. A 1–75 lux threshold, and what you can connect The switching point is set by a potentiometer between 1 and 75 lx: set low, the sensor waits for full darkness; set high, it switches at dusk. The output handles 1000 W of resistive load, but for fluorescent lamps with electronic ballast the limit drops to 250 W — the figure most often overlooked when sizing a circuit. The sensor itself draws just 0.7 W. Several units can be interconnected by cable where one circuit serves several sides of a building. Built for outdoors The housing is UV-resistant plastic, so the anthracite finish will not grey out after two summers. IP54 protects against dust and splashing water from any direction, and the operating range of -20 to 40 °C covers a northern winter. The device is protection class I and needs an earth conductor. STEINEL covers it with a three-year manufacturer's warranty. Specification Manufacturer and model: STEINEL NIGHTMATIQ, article no. 066130 Type: twilight switch (photoelectric lighting controller), no motion detection Mounting: surface, on a wall, outdoors Switching threshold 1–75 lx, set by potentiometer Switching capacity: 1000 W resistive, 250 W for fluorescent lamps with electronic ballast Own power consumption 0.7 W Several units can be interconnected by cable Supply 220–240 V, 50–60 Hz Dimensions 38 × 95 × 95 mm Weight 0.128 kg Protection class I, IP54 Ambient temperature -20 to 40 °C Material: UV-resistant plastic, anthracite Manufacturer's warranty: 3 years EAN 4007841066130Több megjelenítése

21 555 Ft-tól

1 ajánlat

Ajánlatok megtekintése