Dynacord

Dynacord C2800FDi Install DSP Power Amplifier, 2 x 1300W at 4 Ohm, Class H, 70V or 100V Line, FIR Drive, 2U

Name: Dynacord C2800FDi Install DSP Power Amplifier, 2 x 1300W at 4 Ohm, Class H, 70V or 100V Line, FIR Drive, 2U
Brand: Dynacord

The Dynacord C2800FDi is a two-channel Class H DSP power amplifier for permanent installation, rated at 2x 1300W into 4 ohms and stable down to 2 ohms. It can also drive 70V or 100V lines directly on both channels. It has Euroblock connections, onboard FIR-Drive speaker processing and remote power and preset control, and suits bars, restaurants, houses of worship, sports halls and performing arts venues. 2x 1300WInto 4 ohms2x 2200WInto 2 ohms70V / 100VDirect drive2URack height FeaturesTwo channels, 2x 1300W into 4 ohms, 2x 2200W into 2 ohmsBridged output of 4400W into 4 ohmsDirect drive of 70V or 100V lines on both channels, 2x 1250W at 70V (bridging not recommended for high-impedance lines)Euroblock input and output connections for fixed installationOnboard DSP per channel: PEQ, 31-band GEQ, limiters and output delay, with FIR-Drive filtersRemote power on via switch with selectable delay, inputs for preset selection and floating relay contacts for protect statusPower-saving standby modeProtection against over-temperature, DC, HF, back-EMF and peak current, plus inrush limiting and turn-on delayFront-to-rear cooling with three-stage fans SpecificationsOutput power, both channels driven2 ohm: 2200W, 2.7 ohm: 1800W, 4 ohm: 1300W, 8 ohm: 650WOutput power, single channel2 ohm: 2300W, 2.7 ohm: 2000W, 4 ohm: 1400W, 8 ohm: 700WBridged output4 ohm: 4400W, 8 ohm: 2600WHigh-impedance operation70V: 2x 1250W; bridged high-impedance not recommendedOutput stageClass HFrequency response10 Hz to 21 kHz (±1 dB)Signal-to-noise ratio>107 dB (A-weighted)THDShow more

from £1,338.00

1 offer

See all offers